How To Use
1. Install the Lens Guards
Align the notch on the Lens Guard with the lower right slot of the lens, as shown below. Then, rotate the Lens Guard clockwise until the notch is aligned with the microphone.
Repeat with the second lens.
2. Confirm Installation After the Lens Guard is installed on the screen side, an icon will appear in the carnera's status bar, followed by a popup
message. Tap the prompt to confirm.
3. Remove the Lens Guards Hold down the edge of the base of the Lens Guard as shown and rotate counterclockwise to remove. After removal, the icon in the status bar will disappear.
Note
1. Do not apply too much pressure when installing or removing a Lens Guard, as this maydarnage or change the shape of the base.
2. Ensure both Lens Guards are securely installed before using the carnera. The notch of each Lens Guard must be aligned with the camera's microphone. If the notch isn't
aligned, the carmera will not be able to recognize the Lens Guard.
3. Only once the screen-side Lens Guard is installed will the icon display on the camera's status bar and the popup message appear.
4. If you install the Lens Guards while the camera is recording, saving, updating or formatting, the camera will dsplay the status icon but not the prompt.
5. The Lens Guards may slightly affect the camera's stitching ability. To get the best results, point one lens at your subject.
6. Dirty or worn Lens Guards may affect overall image quality.
7. Avoid using the Lens Guards in wet conditions as their seal is not waterproof.
8. If the Lens Guards do get wet, dry each lens thoroughly with a soft cloth to avoid fogging.
9. The Lens Guards contain magnets. Keep them away from pacemakers and other devices affected by magnetic interference.